|
|
|
Abstract Objective To prepare a Zn-2Ag-0.4Mg porous alloy scaffold and study its compatibility，osteogenesis and antibacterial properties in vitro.Methods In this study，pure silver and magnesium were fused into Zn-2Ag-0.4Mg porous alloy under the protection of Ar+2%SF-6 at 650℃.The alloy was divided into zinc group，zinc silver group，zinc silver magnesium group，and control group.The cytotoxicity was measured by Methyl Thiazolyl Tetrazolium (MTT) method.The cytoskeleton was stained with penicin method，the osteogenic properties were tested by alizarin red staining and alkaline phosphatase (ALP) measurement，and the antibacterial properties were tested by the mode of Staphylococcus aureus co-culture.Results Zinc，magnesium and silver alloy had lower cytotoxicity.The experimental results further confirmed that zinc-magnesium-silver alloy had lower toxicity，and thus had better cytocompatibility，better osteogenesis and antibacterial properties.Conclusion The addition of magnesium improves the osteogenic properties of the material，the addition of silver significantly improves the antibacterial properties of the material，and the addition of two elements improves the cytocompatibility and osteogenic properties of pure zinc.Therefore，zinc magnesium silver alloy is expected to be a new choice material for orthopedic implants，especially in the field of bone defect or fracture repair.
|
|
|
|
Corresponding Authors:
Wang Jian
|
|
|
|
［1］Yuan W，Xia D，Zheng Y，et al.Controllable biodegradation and enhanced osseointegration of ZrO-2-nanofilm coated Zn-Li alloy：In vitro and in vivo studies［J］.Acta Biomater，2020(105)：290-303.
［2］Dou J，Zhao Y，Lu L，et al.Effect of the second-step voltages on the structural and corrosion properties of silicon-calcium-phosphate (Si-CaP) coatings on Mg-Zn-Ca alloy［J］.R Soc Open Sci，2018，5(10)：172410.
［3］K RR，Bontha S，M RR，et al.Degradation，wettability and surface characteristics of laser surface modified Mg-Zn-Gd-Nd alloy［J］.J Mater Sci Mater Med，2020，31(5)：42.
［4］Xi Z，Wu Y，Xiang S，et al.Corrosion resistance and biocompatibility assessment of a biodegradable hydrothermal-coated mg-zn-ca alloy：An in vitro and in vivo study［J］.ACS Omega，2020，5(9)：4548-4557.
［5］Zhang W，Li P，Neumann B，et al.Chandler-Loop surveyed blood compatibility and dynamic blood triggered degradation behavior of Zn-4Cu alloy and Zn［J］.Mater Sci Eng C Mater Biol Appl，2021(119)：111594.
［6］Hong D，Saha P，Chou DT，et al.In vitro degradation and cytotoxicity response of Mg-4% Zn-0.5% Zr (ZK40) alloy as a potential biodegradable material［J］.Acta Biomater，2013，9(10)：8534-8547.
［7］Wu Q，Zhu S，Wang L，et al.The microstructure and properties of cyclic extrusion compression treated Mg-Zn-Y-Nd alloy for vascular stent application［J］.J Mech Behav Biomed Mater，2012(8)：1-7.
［8］Imamura N，Kawaguchi T，Shimizu H，et al.Effect of three metal priming agents on the bond strength of adhesive resin cement to Ag-Zn-Sn-In alloy and component metals［J］.Dent Mater J，2018，37(2)：301-307.
［9］Ho CS，Martono E，Banerjee S，et al.Alloy formation and chemisorption at Zn/Pt(111) bimetallic surfaces using alkali ISS，XPD，and TPD［J］.J Phys Chem A，2013，117(46)：11684-11694.
［10］Li W，Li N，Zheng Y，et al.Fretting properties of biodegradable Mg-Nd-Zn-Zr alloy in air and in Hank's solution［J］.Sci Rep，2016(6)：35803.
［11］Vojtěch D，Kubásek J，Serák J，et al.Mechanical and corrosion properties of newly developed biodegradable Zn-based alloys for bone fixation［J］.Acta Biomater，2011，7(9)：3515-3522.
［12］Park MG，Choe HC.Corrosion behaviors of Zn，Si，and Mn-doped hydroxyapatite coatings formed on the Ti-6Al-4V alloy by plasma electrolytic oxidation［J］.J Nanosci Nanotechnol，2020，20(9)：5618-5624.
［13］Subramaniam S，Guo MF，Bathena T，et al.Direct catalytic conversion of ethanol to C5+ ketones：Role of Pd-Zn alloy on catalytic activity and stability［J］.Angew Chem Int Ed Engl，2020，59(34)：14550-14557.
［14］Liu L，Yuan F，Zhao M，et al.Rare earth element yttrium modified Mg-Al-Zn alloy：Microstructure，degradation properties and hardness［J］.Materials (Basel)，2017，10(5)：477.
［15］Zhang X，Yuan G，Mao L，et al.Effects of extrusion and heat treatment on the mechanical properties and biocorrosion behaviors of a Mg-Nd-Zn-Zr alloy［J］.J Mech Behav Biomed Mater，2012(7)：77-86.
［16］Li GN，Zhu SM，Nie JF，et al.Investigating the stress corrosion cracking of a biodegradable Zn-0.8 wt%Li alloy in simulated body fluid［J］.Bioact Mater，2021，6(5)：1468-1478.
［17］Jia B，Yang H，Zhang Z，et al.Biodegradable Zn-Sr alloy for bone regeneration in rat femoral condyle defect model：In vitro and in vivo studies［J］.Bioact Mater，2020，6(6)：1588-1604.
［18］Lee JH，Han HS，Kim YC，et al.Stability of biodegradable metal (Mg-Ca-Zn alloy) screws compared with absorbable polymer and titanium screws for sagittal split ramus osteotomy of the mandible using the finite element analysis model［J］.J Craniomaxillofac Surg，2017，45(10)：1639-1646.
［19］Shimabukuro M.Antibacterial property and biocompatibility of silver，copper，and zinc in titanium dioxide layers incorporated by one-step micro-arc oxidation：A review［J］.Antibiotics (Basel)，2020，9(10)：716. |
|
|
���������� 14010702070875��